Garage door fan – So, first of all, you have to define the position where the ceiling fan will be installed. There is a simple and precise test to check how high the fan should be placed: when lifting an arm you should check that it does not touch the fan, which are usually about 2.4 or 2.3 meters, normally and no more than 2.7 m. High. For greater distances, or if the roof is tilted, you can attach an extension pin. On the other hand, if the ceiling of the room is not adequately high, you can install the instrument without a pin – if the model allows – although it will lose its validity.
The original thing to do once the position of the device is dissipated is to fix the support of the garage door fan, so that the cables leaving the ceiling remain inside. To perseverance we will order the motor assembly, bezel, pin and flower. Anyway, let’s begin or continue analyzing which are the parts of a ceiling fan, with which you can begin to do the following steps that we will specify little by little. So what you can start to do is fix the blade holders to the engine.
We recommend that you do not set the blades yet, as they may twist and unbalance the fan. Then attach the flap and trim to the pin and pass the motor cables through the inside of the pin and fix the pin to the motor, using the pin, hook and screws. Be careful not to damage the cable when inserting the pin into the post. The next process is to attach garage door fan, i.e. hang the accumulated we have instructed the bracket. To do this, insert the coupling of the end of the shaft into the open ring of the bracket, and align the groove. The engine should remain hanging but subject.